Sawmill Blade Guide Roller 1-1/4" Blade Bandsaw Homemade MILL 1/2" Bore Bearings
Zoom

Sawmill Blade Guide Roller 1-1/4" Blade Bandsaw Homemade MILL 1/2" Bore Bearings

Item# C9
$68.00
Availability: Usually ships the next business day.

Veteran Owned and operated

Sawmill or Bandwill Blade Guide Roller

****For use with 1-1/4" Sawmill Blade****

If you are building a homemade sawmill. These rollers are a must to help keep the blade in place while cutting

Qty-1 Bolt not included

**** Manufactured right here in Texas ****

I take a piece of 1018 round stock and use a manual lathe to mill it down to the following sizes..

No mounting hardware.. you are buying just the roller guide and two bearings installed.. Bearing number will be on side of each one.. and they are easy to replace when necessary..tightened bolt keeps bearings compressed, no snap rings to deal with

Roller Guide weighs app. 1.3 Lbs..My guide is designed to help keep vibration down during operation

Bolt and blade are for illustration purposes only and not included

Bearing in front will have a looser fit than bearing in back for ease of replacement when needed..these are not the press fit design

Designed for 1-1/4" blades only

Sealed bearings

1.275" across widest point of roller guide (Front to Rear)

App. 1.00" wide where blade rides on pulley

2.464" wide Overall back flange diameter

3-Grooves for dust partical clean out

Flange at rear is app. 0.245" wide

Diameter of pulley where blade rides is app. 2.00"

Bolt/shaft size for bearings 1/2"

Double sealed bearings..

I didn't oil this piece dowm after maching, so it will have minor cosmetic surface rust

1/2" spacer may be necessary when installed, depending on your set up..Not included

If you have any questions.. Drop me an email.. I plan on machining some for the 1-1/2" blade next

Check out our sawmill builds on youtube under Larry Sbrusch

C9

If you need more than one of these , visit my store under industrial section

Scroll to top